Silvercrest SWV 1166 A1 Operation And Safety Notes page 60

I want to setup the repeater with my PC, but I
cannot connect using the LAN cable.
You need to plug one side of the LAN cable in the repeater,
and the other side of the cable in the PC. This connection
needs to be directly, no device in between. If the repeater
was set-up before, you first need to reset the repeater. You
should also temporarily turn off the wifi from your PC. Also,
your PC needs to be set to "Obtain IP address automatically".
This is commonly the case. If your PC is set to a fixed IP
address or Proxy, you need to set your PC temporarily to
"Obtain IP address automatically."
This setting can be found here: "Start"- "Control Panel"-
"Network"- "Adapter Settings" – "LAN connection" –
"Properties" – "Internet Protocol version 4 (IP / IP4)". Write
down the current settings and then choose "Obtain IP address
automatically" and "OK".
After the repeater is set up, you need to enter the original
settings. *** Depending from your Windows version, some
options may have a different name, e.g. "Network center"
instead of "Network".
60 GB / IE