Advertisement
FlavorFusion Icemaker Adaptor Kit Installation Instructions
5. Place icemaker on top of the adapter lid
(see Figure 3). Dimensions in Figure 3 are
to aid in installation only. Be sure that the
icemaker ice drop tubes are clearly within
the adapter lid opening. Failure to do so
may cause damage to icemaker.
6. Apply continuous bead of NSF international
(NSF) listed silastic sealant (Dow 732 or
equivalent), to seal the icemaker to the top
of the adapter lid. All excess sealant must
be wiped away immediately.
7. Install the icemaker mounting brackets as
shown in Figure 4. Using the brackets as a
template, drill .136 diameter (#29 drill size)
holes into the icemaker cabinet and the
adapter lid. Use care not to drill into any
icemaker components (condenser, tubing,
etc.). Secure the brackets using the #10
sheetmetal screws provided.
8. Follow the icemaker manufacturer's instruc-
tions to complete the installation of the ice-
maker including the bin thermostat.
9. Secure the manual ice fill cover in position
on the lid over the rear hopper access
opening with thumb screw. Note that the
gasket should be compressed to form a
seal against the icemaker cabinet with the
cover secured in position
NOTE: Bracket location will
depend on ice maker model.
10. Reconnect electrical power to the dis-
penser.
11. Verify the function and operation of both the
icemaker and dispenser.
Installation is complete. For optimal
performance, do not fill ice bin more
than 2/3 capacity (maximum fill is 4"
below top of bin).
Publication Number: 629097219INS
Rear of Dispenser
Front of Dispenser
- 2 -
Manual Fill
Cover
Icemaker
Adapter
Lid
Figure 3
Icemaker
Manual Fill Cover
Icemaker Mounting
Brackets
Figure 4
© 2013-2014, Cornelius Inc.
Advertisement
