Setup; Connecting The Printer; Setting Up The Thermal Receipt Printer; Preparing Image Data - Sony SNAPLAB UP-CR20L Connection Manual

Setup

Connecting the Printer

Connect the Thermal Receipt Printer to the UP-CR20L's
RS-232C connector with an RS-232C cable.
TM-T88 III/TM-T88 IV
Thermal Receipt Printer
Cable to use: RS-232C cross (reverse) cable
(9-pin D-sub female - 25-pin D-sub male)
Setting Up the Thermal Receipt
Printer
Set the DIP switch on the Thermal Receipt Printer
according to the following chart. For details on how to set
the DIP switch, refer to the operating instructions for the
Thermal Receipt Printer.
Baud rate 38,400 bps
Handshake XON/XOFF protocol
Data length 8 bits
Parity check None
Recommended DIP switch settings:
SW1
1-1
1-2
1-3
1-4
1-5
1-6
1-7
1-8

Preparing Image Data

Perform the following steps to prepare image data.
1
Create the image data on your computer.
2
Copy the image data onto an expansion CompactFlash
card.
The following gives detailed information on the above
steps.
RS-232C
cable
Creating Image Data on Your Computer
Create the image data according to the following
specifications.
Specifications for job ticket images
Image size: 360(H) × 2 to 360(V) pixels
Format: 24-bit Windows BMP
File storage location: \Sony\UPCR20\Ticket
Data file name for upper image: Logo.bmp
Data file name for lower image:
A combination of letters and numbers that indicate the
print type and print size are used for file names. Name
the data files as follows.
When creating an image for the initial fee, name the
data file "INIT_FEE.bmp".
Example: P_3x5.bmp
A Letters that indicate print types
Print type
Select & Print
Index print
Split image
SW2
OFF 2-1 OFF
OFF 2-2 OFF
ON 2-3 OFF
OFF 2-4 OFF
OFF 2-5 OFF
OFF 2-6 OFF
ON 2-7 OFF
ON 2-8 OFF
A B
Finish
Glossy
ProMatte
Glossy
ProMatte
Glossy
ProMatte
Letters
P
PM
I
IM
S
SM
4
Setup