Topside Control Guide - BarefootSpas PL8 Owner's Manual

~Topside Control Guide~

Start-up
When your spa is powered up, it will go into priming mode. The display will read RUN PMPS PURG AIR ----.
Priming mode can last up to 10 minutes, press WARM or COOL to manually exit the priming mode.
Temperature settings (80°F - 104°F)
The last measured temperature is constantly displayed on the topside's LCD. Press "Warm" or "Cool" once
to display the set temperature. Each time either button is pressed again, the set temperature will increase or
decrease. After three seconds, the current temperature will resume on the topside's LCD.
Jets
Press "Jets 1" once to turn on the primary pump, press again to shift between high and low speed. If your
model has any additional pumps, they will be displayed as "Jets 2" and "Jets 3", press the button once to
turn on the pump desired. Secondary pumps are only 1-speed pumps. All pumps will timeout if left in
highspeed as a safety precaution.
Heating the Spa
The heater and "Jet 1" will run on the low setting until 1 degree below the temperature selected. Then, "Jet
1" will run in the low setting WITHOUT the heater until 1 degree above the temperature selected. Once the
set temperature is exceeded by 1 degree, both the heater and "Jets 1" will remain off until the water drops to
the temperature selected.
9