Filter Mode - Beachcomber Hot Tubs ET-1000 Reference Manual

The filter mode screen will help you set up your ideal filtration and heating settings. Choose, set
or modify one of the 5 suggested modes depending on your needs at any given time.
Away from home Standard-Beginner
In this mode the
hot tub will
alwayssbe in
economy; the set
point will be
reduced by 20° F.

filter mode

To modify a Filter mode category, touch
the pen icon at the right end of the
desired water care to open the
selected Water Care menu.
Note: The default Filter Mode for Hot
tubs equipped with a Hush pump is
"Standard-Beginner" and is programmed
to filter 24 hours (2 x 12hr) per day.
1st filter cycle @ 8:00am
•
2nd filter cycle @ 8:00pm
•
*In economy mode, the set point
will be reduced by 20°F - which
means the heating system will not
be engaged unless the temperature
falls to 20°F below the hot tub's set
temperature.
Default Settings
You can reset all Filter Modes back
to original factory settings by
pressing "Default Settings".
Filter Mode
(default filter mode)
The hot tub will never
be in economy mode
and will be filtering
according
to the management
system's low level
configuration.
modifying filter mode schedules
*economy
Touch the Economy tab to change the
economy schedule. You can add
economy schedules by touching the
orange line labeled "Add Economy" .
To delete a schedule, touch the
garbage can icon at the right end of
the desired line.
You can modify the programmed
schedules by selecting one and
adjusting the schedule.
You have several possibilities for the
schedule (Mon-Fri, weekend, every
day, or single days). The schedules
will be repeated every week. The
time and duration are set in 30
minute increments.
Press "Confirm" to reset. Press
"Cancel" if you choose not to reset.
Energy Savings
The hot tub will be in
economy mode during
the peak hours of the
during peak hours,
day and resume
normal mode on
the weekend.
Super Energy
Weekender
The hot tub will
The hot tub will
be in economy
always be in
mode from
economy mode
Monday to Friday,
and will run
every day of the
normally on the
week.
filter cycles
Touch the Filter cycle tab to change
the filter cycle schedules. You can add
filtration schedules by touching the
orange line labelled "Add filter cycle" .
To delete a schedule, touch the
garbage can icon at the right end of
the desired line.
Once you have set the schedule,
press "Confirm". If you don't want to
keep any changes, press
"Cancel" or use the calendar icon to
go back.
weekend.
3