Accessing The Instrument (Panel „Control") - SARAD MyRIAM User Manual

MyRIAM
at the PC and if it is not occupied by another software. Port numbers above COM9 are not
accessible. Normally, virtual COM ports are linked to port numbers higher than COM2. If
required, the COM port number can be reassigned by the Windows system control panel.
Accessing the instrument (panel „CONTROL")
START
Clears all old measurement data and starts a new sample with or without pump depending
on the selected operation mode (either „Sampling Mode" or „Filter Analysis"). If the button
has not been locked, the sample can be started also by pressing the button.
STOP
Stops the running sample (if not yet stopped) and loads the acquired data and the instrument
information from the Myriam to the PC. During the data transfer, the number of received
messages will be displayed.
READ
Reads the stored data from the instrument without stopping the sample. To get the recent
display data, press the button "RECENT" within the "RESULTS" panel.
Opens the dialog window for the instrument set-up. The actual parameters can be
read even if a measurement is in progress. However, it is necessary to stop the
measurement if the parameter shall be changed.
Switches off the Myriam. To switch on the instrument again the push button has to be
used. It is not possible to switch on the unit by software
Manual_Myriam_EN_10-04-08.doc
- 13 -
(c) SARAD GmbH