NookBox E6309666 Installation Manual

Siren indoor

Advertisement

Quick Links

NookBox
Installation Guide
Siren Indoor
1
Installation Guide
NookBox Siren Indoor
(P119017 /E6309666)

Advertisement

Table of Contents
loading

Summary of Contents for NookBox E6309666

  • Page 1 NookBox Installation Guide Siren Indoor Installation Guide NookBox Siren Indoor (P119017 /E6309666)
  • Page 2 Installation Guide Siren Indoor NookBox Siren Indoor (P119017 / E6309666) The Indoor Siren is used to attract attention by sounding an alarm when alarm signal is received from Control Panel. The Siren can also alert you to tamper violation, signal communication problems and low battery status.
  • Page 3: Parts Identification

    NookBox Installation Guide Siren Indoor Parts Identification 1. Battery Compartment (With a lid secured with 4 screws) 2. Function Switch Block Contains 7 DIP Switches to enable the learning mode and to set the alarm period of siren and strobe light.
  • Page 4: Power Supply

    NookBox Installation Guide Siren Indoor DIP Switch Position Table Remove the cover by unscrewing the single screw located at the bottom. In the middle of the L-shaped PCB board, you can see a Jumper Switch Block which consists of 7 DIP Switches. The function of each DIP Switch is listed as table right.
  • Page 5: Function Overview

    NookBox Installation Guide Siren Indoor Function Overview Siren Audible Performance The siren produces a minimum of 104 dBA sound pressure at 1 meter on axis. It is programmable via two DIP switches (SW3 and SW4) for four different siren durations: 3 min.
  • Page 6: Getting Started

    NookBox Installation Guide Siren Indoor Getting Started Learning the Siren Step 1 Release the screws at the bottom of the Siren and remove the front cover. Step 2 Open the battery compartment cover and insert batteries. Step 3 Locate the Function Switch Block; use a sharp object to slide Dip SW3 & SW4 on the Siren function switch block for your desired alarm period.
  • Page 7 NookBox Installation Guide Siren Indoor Programming the Siren Step 1 Locate the Control Panel “Program Siren” menu, Refer to Control Panel manual for detail. Step 2 Make sure the Siren is in the normal operation mode. Step 3 Set the “Siren Tamper”, “Confirm” and “Entry Sound” to ON or OFF at your discretion and click on those functions’ corresponding buttons accordingly.
  • Page 8 NookBox Installation Guide Siren Indoor For more information visit: www.getnookbox.com...

This manual is also suitable for:

P119017

Table of Contents