Advertisement
Advertisement
Table of Contents
Related Manuals for Pitsco Education SunEzoon Car
Summary of Contents for Pitsco Education SunEzoon Car
-
Page 1: User Guide
User Guide 59021 V0808... - Page 2 Exploring the Sun’s energy is easy with this SunEzoon Car Kit. No soldering is necessary – only simple assembly and cutting skills are required. Materials Included • 2 large rear wheels • 2 small front wheels • 2 axles • 4 nylon axle bushings • Gear font • Motor • Motor mount • Chassis plate...
- Page 3 Axle Bushing 18th row Axle Bushing Drive Wheels Wheels Gear 2nd row Figure 1 Axle Bushing 5) Insert the axle into one of the back axle bushings. Push it until the end comes out the axle bushing on the other side. Push the other rear wheel on the axle end (Figure 1). Make sure the parts are not too tight or the wheels and gear will not turn properly. 6) Push the other axle into one of the front wheels. Slide this axle through the front axle bushings. Push the other front wheel onto the free end of the axle (Figure 1). Again, make sure the parts are not too tight. 7) Push the pinion gear onto the motor shaft. Snap the motor into the motor mount. 8) Turn the motor so the pinion gear is on top of the drive gear and the motor is between the two rear wheels. Let the gears mesh together and the pinion gear roll forward until the motor mount rests on top of the chassis (Figure 2). The gears should still be meshed but not too tightly. If they are too tight, the gears will not work properly. Practice this until you are sure...
- Page 4 9) Clip the black and red wires from the solar panel to the motor connection terminals. You might need to turn the motor in the mount so the connection clips do not stick up and interfere with the solar panel placement. 10) Place an adhesive tab on the back of the solar panel near the wire end. Peel the paper backing off the tab and carefully place the solar panel on the car so it angles down from the motor to the chassis. The tab should rest on the motor and the other end of the panel will be near the front of the car (Figure 3). Adhesive Solar Panel Motor in Motor Mount Chassis Figure 3 11) Following the directions on the car body cutout, cut and fold the car body. 12) With the blank underside of the cutout facing up, place an adhesive tab on the two tabs that extend from the cutout. Practice folding the cutout over the car so the tab on the wide end is aligned with the car’s back and the tab on the narrow end is at the front. The cutout should fit over the car so the solar panel shows through the hole in the cutout.
Need help?
Do you have a question about the SunEzoon Car and is the answer not in the manual?
Questions and answers