Table of Contents
Advertisement
- Mount set 2 in the same way as set 5 is mounted.
4. Fix the top set (i.e., set 2 shown below) with the locking bolts so that it does not move vertically.
5. Adjust the gap (seam) between sets 8 and 9 by moving set 9 vertically and horizontally. After this, fi x set 9 with
the locking bolts so that it does not move vertically.
12
Remove the module-protecting Cover.
(The protective Cover is attached on all four sides; only
remove fi rst the Cover on the sides where the sets meet.)
2
5
8
2
5
8
9
A
A
*
Advertisement
Table of Contents
