Related Manuals for JB Systems WBS-200
Summary of Contents for JB Systems WBS-200
- Page 1 WBS-200 Wireless Belt Pack System A DIVERSITY B WMS-100 Wireless Handmic System A DIVERSITY B ENGLISH Operation Manual Other languages can be downloaded from: WWW.JB-SYSTEMS.EU Version: 1.0...
-
Page 3: Before Use
• 1x mono jack/jack cable • 1x mains DC power adapter • WMS-100 system → 1x WMIC-100 wireless mic • WBS-200 system → 1x WBS-200 belt pack + Lavalier mic + windscreen + tie-clip JB SYSTEMS WMS-100 + WBS-200 ®... -
Page 4: Safety Instructions
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the an- tenna or the device is permitted. Any change to the antenna or the device could result in the device exceed- ing the RF exposure requirements and void user’s authority to operate the device. JB SYSTEMS WMS-100 + WBS-200 ®... -
Page 5: Receiver Functions
6. Battery Cover: unscrew it gently and slide it down to open the battery compartment or have access to the channel selector (5). 7. Antenna: Built-in high gain helical antenna. JB SYSTEMS WMS-100 + WBS-200 ®... - Page 6 • To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full performance. • Also check the extra notes in the chapter “SETUP and CONNECTIONS” JB SYSTEMS WMS-100 + WBS-200 ®...
-
Page 7: Setup And Connections
Use the supplied JACK/JACK cable to connect the receiver “JACK-output (6)”. Switch the transmitter (hand mic/belt pack) on and bring the input gain of the mixer slowly up. NOTE: never use the balanced and unbalanced outputs together, this will results in signal loss and in- creased noise. JB SYSTEMS WMS-100 + WBS-200 ®... -
Page 8: Troubleshooting
• Check if the transmitter is too far away from the receiver or SQUELCH control is set too high. • Check if the receiver is located near a large metal object or if there are large obstruc- tions (ex. large metal object or thick wall) between transmitter and receiver. JB SYSTEMS WMS-100 + WBS-200 ®... -
Page 9: Cleaning The Appliance
Meets the essential requirements as described in the R&TTE directive 1999/5/EC, based on the following standards applied: EN 300 422-2 : V1.2.2 (2008-03) EN 301 489-01 V1.8.1 (2008-04) EN 301 489-09 V1.4.1 (2007-11) EN 60065:2002+A1:2006+A11:2008 JB SYSTEMS WMS-100 + WBS-200 ®... -
Page 10: Specifications
Beglec NV ~ ‘t Hofveld 2c ~ B1702 Groot-Bijgaarden ~ Belgium Groot-Bijgaarden, July 25th 2009 For Beglec NV, Luc De Bauw Director NOTE: WMS-100 wireless set contains:1pc WMIC-100 + 1pc WR-100 WBS-200 wireless set contains: 1pc WBP-200 + 1pc WR-100 SPECIFICATIONS RECEIVER Carrier Frequency Range: UHF band 0,005% Frequency Stability: @ 5μV S/N ratio >80dB...