The Points You Have To Know Before Using Vita Juice - SEMAK Vita Juice VJ2012 Operating And Instruction Manual

The points you have to know before using Vita Juice.

1. For assembly and disassembly (Order of assembly and disassembly)
◆ Assembly
◆ Disassembly :
2. How to put the material for operation
◆ The material shall be put slowly because Vita Juice juicer revolves 47 times per
minute. It is not overloaded and squeezing properly when the hard or sticky fiber
is cut into small pieces.
◆ The reverse button shall be pressed for 2~5 seconds before disassembly after
use and it will be opened when it is disassembled after removing the leftover
with normal direction operation.
3. In case of stop during operation
◆ It can be created by putting large quantity of hard and sticky fiber material comparing
to the RPM, or material is jammed in between the screw and juice strainer.
Press the stop button and press the reverse button 3~5 seconds and start it again
with button for normal direction. (It can be repeated in 2~3 times.)
4. When the container lid is not opened after operation
See paragraph 3. Press the reverse button 2~3 times and start it in normal
direction to remove the leftover food completely and it will be opened smoothly.
5. How to prepare the material
◆ Hard vegetables (Carrot, beat, radish and sweet potato etc.)
☞ It is proper to cut straight in 2 cm of thickness.
◆ Material of sticky fiber (Angelica)
☞ The leaves and stem of angelica shall be divided and the stem shall be cut in 2cm.
◆ How to prepare fruit
☞ It is good to cut into many pieces after washing according to the size of input hole and
it is good to remove the seeds when they are big and hard (Peach, mango and jujube).
◆ The hard grains (Bean, red bean and lentil) shall be used after soaking into the water.
It will be a reason for overloading or damage on the machine.
14
: Attach the container to the closing direction (Clockwise) of container grip
part on the main body. Install the Rotaiting brush →Sqeezing Basket
→Screw and assemble the lid of the container completely
to the closing direction (Clockwise) of container grip part.
Disassemble the container lid by turning to opening direction
(Counterclockwise) and separate the main body and container.
Clean it with brush and keep it after complete drying.
Make sure attach according to the assembly order surely because
the assembled container set can not be attached on main body.