Connecting The Power Cable; Connecting To The Host Computer - Sony STORSTATION LIB-D81 Operating Instructions Manual

Connecting the Power Cable

Connecting to the Host Computer

1
Make sure that the power switch on the rear of the AIT autoloader is in the
off position (a is depressed).
2
Connect one end of the power cable to the power supply connector and the
other end to the power outlet.
Connect the AIT autoloader and the host computer with a SCSI cable. This
section explains general connection steps. To connect, use an Ultra2 Wide SCSI
LVD cable commonly sold in stores. However, when using a model equipped
with an AIT-3 drive, use an Ultra 160/m SCSI LVD cable. The autoloader side
uses the 68-pin half pitch connector.
When connecting other SCSI devices along with the AIT autoloader, see
"Connecting SCSI Peripheral Devices" (page 22).
Caution
• Do not connect the AIT autoloader to the HVD (High Voltage Differential)
SCSI bus. If connected, the autoloader or other devices on the SCSI bus may
be damaged.
17
Chapter 2 Installation