Hardware Setup - iC-Haus iC-PZ Getting Started Manual

iC-PZ AN1
GETTING STARTED GUIDE iC-PZ

HARDWARE SETUP

To configure iC-PZ using the graphical user interface
software, the hardware has to be connected as follows:
1. Connect the scanner module to the motherboard
via the included 20-pin ribbon cable.
2. Connect the motherboard to the BiSS-to-PC
Adapter.
3. Connect the BiSS-to-PC Adapter to the PC via
the usb cable. Please make sure you have in-
stalled the related driver before connecting the
BiSS-to-PC adapter to your PC.
4. Ensure the jumper setup of the scanner module
is in default configuration:
• CFG_0/ JP1 = M (= VDDIO/2)
• CFG_1/ JP2 = L (= GNDIO)
• CFG_2/ JP3 = H (= VDDIO)
Figure 2: Scanner module (iC-PZ2656 EVAL PZ1M)
and code disc PZ03PS in detail
5. Ensure jumper setup of motherboard is in the
following configuration:
• JP1 = Closed (VDDIO supplied by VDDA)
• JP2 = Closed (GNDIO connected to GNDA)
• JP3 = Open
• JP4 = Open
• JP5 = Closed (BiSS Port enabled)
Figure 3: Motherboard (iC-PZ EVAL PZ1D) in detail
6. Connect a 5V power supply to the motherboard.
Rev A1, Page 3/10