Filter Replacement Instructions; Troubleshooting Guide - Whirlpool WHKF-IMTO Installation, Use & Care Manual

5. Turn on the incoming water supply and flush the filter into a
bucket. Run water for 5 minutes to flush out air
(see Figure 3).
6. Shut off water supply again. Referring to "Using Push-In
Fittings" section, insert water supply tube from refrigerator
into outlet fitting (see Figure 4).
Outlet
7. Turn on water supply to refrigerator and check for leaks.
Figure 3
Figure 4
Filter Replacement
The contaminants or other substances removed or reduced by
this water filter are not necessarily in all users' water.
Filter life varies depending on local water conditions and the
volume of water used. We recommend that you change this
filter every 6 months. However, it can be replaced earlier if
there is a drop in flow rate at the refrigerator's water dispenser
(if present) or if the ice maker's performance deteriorates.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.

Filter Replacement Instructions

1. Turn off water supply to refrigerator.
2. Referring to section "Using Push In Fittings", release tubing
from both ends of filter.
3. Referring to "Using Push-In Fittings" section, insert
refrigerator water supply tubing into inlet push-in fitting on
filter.
4. Turn on the incoming water supply and flush the filter into a
bucket. Run water for 5 minutes to flush out air.
5. Shut off water supply again. Referring to "Using Push-In
Fittings" section, insert water supply tube from refrigerator
into outlet fitting.
6. Turn on water supply to refrigerator and check for leaks.

Troubleshooting Guide

Water leaks at connections: Push tubing in as far as it will
go. If leaking continues, shut off water at the original valve
and remove water line by pushing in on the connector collar
while pulling the tubing away. See, "Using Push-In Fittings".
Inspect tubing for cracks and scratches. If tubing is cracked
or scratched, simply cut that portion away and reinsert tubing
into push in fitting.
Make sure tubing is cut straight. If not, recut.