Attaching The Unit Stand - Sony PCWA-A100 Operating Instructions Manual

Attaching the unit stand

The unit stand allows you to place your Access Point in an upright
position.
When the unit stand is attached, cables are routed through the recessed
groove.
Before attaching the unit stand
Make sure to write down the six-digit Access Point ID on the label
attached on the bottom surface of the Access Point.
Access Point ID
Note
Depending on the type of Ethernet cable used, it may be impossible to install the
stand.
Attach the unit stand to the Access Point as shown in the figure
below.
Engage Joint A with Joint B and slide the Access Point in the direction
indicated by the arrow until it clicks.
Joint B
Joint A
Groove
z Tip
The unit stand may be attached in either direction.
To remove the unit stand
Slide the Access Point and unit stand in opposite directions to detach.
20