Sony DMX-WL1 Startup Manual page 13

4
Press  to highlight Category (equipment
type), and press
Select an equipment type from the list, and
press .
S e t u p / I R B l a s t e r / H D M I 1
C a t e g o r y C a b l e B o x
M a k e r S a t e l l i t e
C o d e V C R
Te s t ( P o w e r DV D
S a v e a n d E x B D
R e c e i v e r
5
Press  to highlight Maker, and press
Select a manufacturer from the list, and press
.
S e t u p / I R B l a s t e r / H D M I 1
C a t e g o r y S o n y
M a k e r L G
C o d e P a n a s o n i c
Te s t ( P o w e r P h i l i p s
S a v e a n d E x P i o n e e r
S a m s u n g
6
Press  to highlight Code, and press
Select a code from the list, and press
S e t u p / I R B l a s t e r / H D M I 1
C a t e g o r y B D 1
M a k e r B D 2
C o d e B D 3
Te s t ( P o w e r O n / O f f )
S a v e a n d E x i t
See page 15 on Reference Guide if your
code is not on the list.
• When more than one code is available for your
manufacturer, start checking from the top of the list for
the code that operates your equipment.
.
.
.
.
7
Press  to highlight Test (Power On/Off)
and press .
Test to see if the selected equipment power
turns on and off.
You may need to test more than one code to
find the right code for your equipment.
• If the equipment's supplied remote control has both
POWER ON and POWER OFF buttons, using Test
(Power On/Off) might not work to test the IR code.
Select Save and Exit then check if any other remote
buttons will operate your equipment.
S e t u p / I R B l a s t e r / H D M I 1
C a t e g o r y B D
M a k e r S o n y
C o d e B D 1
Te s t ( P o w e r O n / O f f )
S a v e a n d E x i t
8
When you have found the right code, press  to
highlight Save and Exit, and press
Save the setting and exit from the Setup
menu.
S e t u p / I R B l a s t e r / H D M I 1
C a t e g o r y B D
M a k e r S o n y
C o d e B D 1
Te s t ( P o w e r O n / O f f )
S a v e a n d E x i t
• Do not connect two of the same equipment from
the same manufacturer (Eg. two Sony Blu-ray disc
players), you will not be able to control each equipment
individually.
• To erase the code, select Category, then press  to
highlight "----" and press
.
in step 4.
13