LOCKEY USA SUMO GL2 Installation Instructions

Part # Part Name
1 Mounting Bracket A
2 Mounting Bracket B
3 Mounting Bracket C
4 Security Guide Bolt
5 Keyed Guide Bolt Receiver
6 Latch Assembly
7 Lock Hood
8 Spindle
9 Strike Assembly A
10 Strike Assembly B
11 Spacers
12 Strike Plate
13 Support Pin
14 Hex Bolts
15 M4 Screws
16 1/2" Self-Tapping Screws
17 1 1/2" Self-Tapping Screws
18 2 1/2" Self-Tapping Screws
19 3/4" Large Phillips Screws
20 Rubber Trim Plate
21 Outside Lock Body
22 Inside Lock Body
23 Flat Head M4 Screws
24 Set Screws
IMPORTANT:
• SUMO mounts on left and right hand gates. SUMO Mounting Bracket A must be mounted on
the pull side of the gate. Lockout feature works on outswing gates. If your gate is an inswing
gate, you may want to switch hinges to allow the pull side of the gate to be the exterior.
• SUMO Mounting Brackets must mount flat on the fence and gate posts.
INSTALLATION INSTRUCTIONS
1. Using Mounting Bracket A (#1), identify the desired placement of the SUMO. The two tabs on
Mounting Bracket A must mount on the inside edge of the gate.
a. Place Mounting Bracket A in the desired position. Temporarily secure with one ½" Self-Tapping
Screw (#16) through the center hole on Mounting Bracket A.
b. On the inside of the gate, locate the bottom tab with a notch in it on Mounting Bracket A.
Draw a straight line from the bottom notch to the edge of the gate (See Diagram 1).
c. Place Mounting Bracket B (#2) on the opposite side of the gate. Line the bottom notch on the
bottom inside tab with the line drawn in Step 1b. (See Diagram 1).
d. Mount and secure Mounting Bracket B with a ½" Self-Tapping Screw through the center hole.
2. Insert Security Guide Bolt (#4) into the bottom hole on Mounting Bracket A with the bolt pointing
towards the fence post. DO NOT tighten set screw at this time.
3. Attach Keyed Guide Bolt Receiver (#5) to the bottom channel of Mounting Bracket C (#3).
Note: The keyed hook MUST be in the locked position in order to slide the Keyed Guide Bolt
Receiver onto Mounting Bracket C. After the Keyed Guide Bolt Receiver is installed on Mounting
Bracket C, unlock the receiver.
4. Hold Mounting Bracket C with Keyed Guide Bolt Receiver to the fence post. Hold in place until the
Security Guide Bolt is centered into the v-groove of the Keyed Guide Bolt Receiver, where the hook
is (See Diagram 2). This will center the locks assembly with the strike assembly.
a. Mark the top of Mounting Bracket C with a pencil.
b. Open the gate. Secure Mounting Bracket C to the post with two ½" Self-Tapping Screws
through the tabs on the inside fence post edge.
c. Close the gate to ensure the Security Guide Bolt and Keyed Guide Bolt Receiver are centered
and you are able to lock the security hook.
SUMO GL2
Installation Instructions
1 2 3
A B
11 12
22
21
(Single Combination)
4
5
C
13 15
14 16
22
(Double Combination)
6 7 9
8
17
18
23
SUMO installed
24
Gate
End
Diagram 1
Gate End
Interior
Notch
Diagram 2
10
19
20
Exterior