SWELLPRO SPRY User Manual
Hide thumbs
Also See for SPRY:
- User manual (40 pages) ,
- User manual (38 pages) ,
- Firmware update instruction (2 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
User Manual
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for SWELLPRO SPRY
Summary of Contents for SWELLPRO SPRY
- Page 1 Remote Controller User Manual www.swellpro.com...
-
Page 2: Remote Controller Illustration
As the remote controller is completely sealed, the air inside is subject to changes in pressure and temperature. If the rubber joystick seals balloon or suck in, simply equalize the pressure inside the remote by briefly opening the USB charge plug. ©2019 SwellPro All Rights Reserved... -
Page 3: Low Battery Alarm
This section introduces the remote controller functions, including the drone operation and the camera operation. Charging Remote Controller Battery The Spry remote controller has a built-in battery and charging circuit. Charge the controller using the supplied micro-USB cable and a regular 5V /2A USB charger. Some USB ports and some USB cables cannot provide the full 2 amps (2A) of power required. -
Page 4: Flight Modes
In the Follow Me mode, the joysticks are disabled. Long-press the “F” button again to cancel Follow Me and resume joystick operation. When the speed of the remote controller exceeds 10m/s during Follow Me operation the Spry will stop following and hover in place. - Page 5 800m. For best reception, keep the left-hand (2.4GHz) antenna horizontal and the right-hand antenna (5.8GHZ) vertical. Camera Gimbal Control Remote Control Operation Description Camera up Camera down Camera up: Tilt camera up Camera down: Tilt camera down ©2019 SwellPro All Rights Reserved...
-
Page 6: Camera Control
(hh:mm) the microSD card can hold. The Spry will automatically save longer video files into chapter files of 4GB. Always stop video recording before powering off the Spry or your video will be lost. ©2019 SwellPro All Rights Reserved... -
Page 7: App Control
APP Control How to Use The Spry remote controller has a built-in WI-FI module that can be used to connect your mobile device and control the aircraft to perform various intelligent automatic flight modes with the Spry APP. APP installation: The Spry app is available for iOS and Andoid devices. Android systems can download the APK from either the Android market or our website www.swellpro.com. - Page 8 2. Tap-to-Fly: Click the “Tap-to-Fly” button, and then click the target points on the map and click the Upload button. The drone will start flying to the point and hover there. If you need to set the parameters manually, you can tap on the flight point. ©2019 SwellPro All Rights Reserved...
- Page 9 flight point to delete it, tap the “Delete” button to delete all flight paths). Tap the flight point again to edit. b.After completing the setup, click the “Upload” button and the drone will fly according to the flight path. 11.2V Lat：113.860667 Ing：22.704291 ©2019 SwellPro All Rights Reserved...
- Page 10 APP control requires a good wireless communication environment. If the drone does not execute the operation command, this may be due to interference, please try again. If the drone continually fails to respond to your APP commands, please operate the drone with the remote controller: quickly switch the Flight Mode switch once, it is suggested to use the GPS mode to take over control.
Need help?
Do you have a question about the SPRY and is the answer not in the manual?
Questions and answers