LCON-Rs in an optical ring structure will be detected and signaled with LED’s and failure relays. The participants are always available as they are connected and addressed via a line structure. This also applies to a failure of the LCON-R system. : 06/04 ERSION Ä...
Clamp the optical connector in a way, that in each case the right channel of one LCON-R is connected with the next right LCON-R and the left channel of the LCON-R is connected with the next adjoining LCON-R on the left.
K1, K2 and K3 for optical channel 1 (CH1) or channel 2 (CH2) over a potential free two-way contact. Green LED “ON“ means that LCON-R is supplied with voltage (24VDC) and that the internal operating voltage of 5VDC is available. Yellow LED “R/T“...
This display can be used to check fiber optic connections. If both receivers of the LCON-R receive signals from the adjoining LCON-Rs, the LED is not shining. The connection of a participant (master or slave) is not necessary for this. The clearing takes place approx.
Page 6
Manual System LCON-R The following diagramm helps with trouble-shooting: : 06/04 ERSION Ä ECHNISCHE NDERUNGEN VORBEHALTEN EITE UBJECT TO ECHNICAL LTERATIONS...
Page 7
= max. delay in the ring RING = number of LCON-R systems in the ring = module delay: delay of the signals in the LCON-R LCON-R = length of fiber optics in the ring = delay per meter fiber optic...
Manual System LCON-R VIEW Connection Technology Optical connection Electrical connection 9 pol. SUB-D female HP - Versatile Link F - SMA Screw clamps F - ST : 06/04 ERSION Ä ECHNISCHE NDERUNGEN VORBEHALTEN EITE UBJECT TO ECHNICAL LTERATIONS...
Page 10
Manual System LCON-R APPLICATION Optical Ring Structure IM FAULT IM FAULT IM FAULT IM FAULT BUS FAULT BUS FAULT BUS FAULT BUS FAULT POWER ON POWER ON POWER ON POWER ON 24 V 24 V 24 V 24 V : 06/04 ERSION Ä...
Need help?
Do you have a question about the LCON-R and is the answer not in the manual?
Questions and answers