Advertisement
BATTERY INSTALLATION/REPLACEMENT
1.
Remove the transmitter's cover (if it is not al-
ready off) as de scribed in MOUNTING Step 1.
2.
Observe correct polarity and insert the battery
provided into the battery holder (see Fig. 2). Take
care not to bend the antenna.
Note : Replace battery only with :
Panasonic CR123A, Duracell DL123A,
Sanyo CR123A, Varta CR123A, or
ADEMCO 466.
3.
To replace the cover, engage the hooks along
one edge and snap shut.
Regular maintenance and inspection (at least annually) by the installer and frequent testing by the user are vital to
continuous satisfactory operation of any alarm system.
The installer should assume the responsibility of developing and offering a regular maintenance program to the user,
as well as acquaint ing the user with the proper operation and limitations of the alarm system and its component
parts. Recommendations must be included for a specific program of frequent testing (at least weekly) to insure the
system's operation at all times.
REFER TO THE INSTALLATION INSTRUCTIONS FOR THE QED RECEIVER/CONTROL WITH
WHICH THIS DEVICE IS USED, FOR DETAILS REGARDING LIMITATIONS OF THE ENTIRE
ALARM SYSTEM.
Alarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions, sub-
sidiaries and affiliates ("Seller"), 165 Eileen Way, Syosset, New York 11791, warrants its products to
be in conformance with its own plans and specifications and to be free from defects in materials and
workmanship under normal use and service for 18 months from the date stamp control on the product
or, for products not having an ADEMCO date stamp, for 12 months from date of original purchase un-
less the installation instructions or catalog sets forth a shorter period, in which case the shorter pe riod
shall apply. Seller's obligation shall be limited to repairing or replacing, at its option, free of charge for
materials or labor, any product which is proved not in compliance with Seller's specifications or
proves defective in materials or workmanship under normal use and service. Seller shall have no
obligation un der this Limited Warranty or otherwise if the product is altered or improperly repaired or
serviced by anyone other than ADEMCO factory service. For warranty service, return product
transportation prepaid, to ADEMCO Factory Service, 165 Eileen Way, Syosset, New York 11791.
THERE ARE NO WARRANTIES, EXPRESS OR IMPLIED, OF MERCHANTABILITY, OR FITNESS
FOR A PARTICULAR PURPOSE OR OTHERWISE, WHICH EXTEND BEYOND THE
DESCRIPTION ON THE FACE HEREOF. IN NO CASE SHALL SELLER BE LIABLE TO ANYONE
FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS OR ANY
OTHER WARRANTY, EXPRESS OR IMPLIED, OR UPON ANY OTHER BASIS OF LIABILITY
WHATSOEVER, EVEN IF THE LOSS OR DAMAGE IS CAUSED BY THE SELLER'S OWN
NEGLIGENCE OR FAULT.
Seller does not represent that the products it sells may not be compromised or circumvented; that the
products will prevent any personal injury or property loss by burglary, robbery, fire or otherwise; or
that the products will in all cases provide adequate warning or protection. Customer un derstands that
a properly installed and maintained alarm may only reduce the risk of a bur glary, robbery, fire or other
events occurring without providing an alarm, but it is not insurance or a guarantee that such will not
occur or that there will be no personal injury or property loss as a result. CONSEQUENTLY, SELLER
SHALL HAVE NO LIABILITY FOR ANY PERSONAL INJURY, PROPERTY DAMAGE OR OTHER
LOSS BASED ON A CLAIM THE PRODUCT FAILED TO GIVE WARNING. HOWEVER, IF SELLER
IS HELD LIABLE, WHETHER DIRECTLY OR INDIRECTLY, FOR ANY LOSS OR DAMAGE
ARISING UN DER THIS LIMITED WARRANTY OR OTHERWISE, REGARDLESS OF CAUSE OR
ORIGIN, SELLER'S MAXIMUM LIABILITY SHALL NOT IN ANY CASE EXCEED THE PURCHASE
PRICE OF THE PROD UCT, WHICH SHALL BE THE COMPLETE AND EXCLUSIVE REMEDY
AGAINST SELLER. This war ranty replaces any previous warranties and is the only warranty made by
Seller on this product. No increase or alteration, written or verbal, of the obliga tions of this Limited
Warranty is authorized.
www.PDF-Zoo.com
TO THE INSTALLER
ADEMCO LIMITED WARRANTY
165 Eileen Way, Syosset, New York 11791
Copyright © 1998 Pittway Corporation
SPECIFICATIONS
Dimensions: 1-1/2"W x 3-1/16"H x 15/16"D
(38mm x 78mm x 24mm)
Battery: 3V Lithium (see Note in step 2 of BATTERY
INSTALLATION / REPLACEMENT )
BATTERY CAUTION
: Risk of fire, explosion
and burns. Do not recharge, disassemble,
heat above 212°F (100°C) or incinerate.
Dispose of used batteries promptly. Keep
away from children.
Advertisement
