Advertisement
Mounting Instructions
NOTE: First turn off electricity.
Wall Mounting
1. Remove mounting plate from fixture.
2. Knockout in back of mounting plate and push wires through
the hole.
3. Securely attach mounting plate to J-box.
Transformer
4. ELECTRICAL CONNECTIONS:
Connect white wire lead from fixture to white (neutral) wire supply
feed from circuit. Connect black (120V) or orange (277V)
(depending on supply voltage) wire lead from fixture to black(hot)
wire from supply circuit.Use U.L. Listed wire connectors suitable
for the size, type, and number of conductors. No loose strands or
loose wires should be present. Secure wire connectors with U.L
listed electrical tape
277VAC
INPUT
Mounting Plate
Junction Box
(Not provided)
120VAC
INPUT
Philips Day-Brite • 776 South Green Street • Tupelo, MS 38804
662-842-7212 • Fax 662-841-5501 • www.daybrite.com
5. Connect transformer to PCB Ass'y.
Transformer Connect to PCB Ass'y
6. Connect red lead to battery positive terminal.
7. Snap fixture onto mounting plate and ensure no wires are
pinched. Make sure unit is fully attached.
8. Restore power and press test button. Battery powered bulb
will come on. AC light will turn off
Ceiling Mounting
1. Open top cover and knockout on the top of fixture.
2. Secure the mounting plate to tube with nut.
Pipe(Not provided)
Pipe Connector
Nut
3. Reference 4 - 8 step in wall mounting above for ceiling
mounting.
PCB Ass'y
Battery
Red Wire
Screw
knockout
Rev A 11/10 Page 1 of 2
Advertisement
