Counters; Failures Display - Dimplex ASCARI MA 12 Installation And Servicing Instructions

6.5 - Counters

The regulation is equiped with 6 counters to count heating cycles (the unit is 100 cycles).
Press and
The setting menu starts (see § 6.3).
Press during 3 sec. :
meaning power breaker #1 K1 is totalling more than 0999 x 100 = 99.900 cycles.
Press to shift to counter #2. Conversely press
Starting this menu will automatically restore the weekly shift of the 6 power stages starting sequence back to
the 1 to 6 order, but will not zero the counters.
Press and

6.6 - Failures display

The boiler has many selectable options. Please ensure the correct selections are made for the type of
installation you have made. If you have selected the use of a room thermostat, or hot water cylinder, the boiler
will not operate until these devices are connected.
The boiler indicates a boiler fault by flashing all segments of the temperature display.
In case of boiler's temperature failure, all 14 LEDs
the water pump still running.
In case of Domestic Hot Water sensor failure, all 14 LEDs
boiler is automatically restricted to heating.
In case of outside temperature sensor failure, all 14 LEDS
restricted to heating.
Please call the Dimplex Customer Service department -see Servicing section-
2 FLASHING SEGMENTS in front of bar -indicate the system pressure has fallen below the minimum operating
pressure.
• Check if water has discharged from the pressure relief valve. If so call a Dimplex service agent.
• Check for leakage in the system.
Once the fault has been cleared the boiler will turn on again if the system is filled and pressurised to over 0.5
bar.
during 3 sec.
°C will be on display for counter #1, alternating with
during 3 sec. to exit the counters menu.
Ascari - 12kW -page 29 -
to return to previous counter.
in front of symbol "°C" are blinking. The boiler is off,
in front of symbol "°C" are blinking. The
in front of "°C" are blinking. The boiler is
°C and bar,