Display Icons; Operation - Hawke LRF Series Manual

DISPLAY ICONS

1. Aim point with horizontal and vertical guides.
2. Distance measurement displayed with 3 digits.
3. Units - "MS" meters, "DEGS" degrees or "YDS" yards.
4. Modes - "BEELINE", "HIGH", "∆HIGH" or "ANGLE".
5. Laser quality - 6 bars or more required for a reading.
6. "LASER" flashes when the laser is in operation.
7. "BATT" displays when the battery power is low.

OPERATION

1. Adjust the diopter setting to get a clear image for your eyesight.
2. When turned on the range finder will start in the same mode it was in when last used.
3. To cycle through the modes simply press the MODE button until you come to the setting you
desire.
4. Simply press the ON button to laze the target you are aiming at.
5. The signal strength is displayed beneath the aim point. A minimum of 6 bars is needed to operate,
10 bars is the maximum strength.
6. The Hawke Laser Range Finder will automatically turn off when not used for 15 seconds.
5
3
4
2
1
5
6 7