Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Rupp Air CFA-D150
Summary of Contents for Rupp Air CFA-D150
- Page 1 Ventilation Fan CFA-D150 (BPT18-44A) It is very important that you read this manual installation for your safety and efficiency of the unit. Please be advised that all units should be installed by a licensed electrician. READ AND SAVE THESE INSTRUCTIONS...
-
Page 2: Table Of Contents
Installation ..............6 Safety Information ............2 Specifications .............. 9 ..........9 CFA-D150(BPT18-44A) Pre-installation .............. 3 ..........DIMENSIONS ......9 Planning Installation ..............3 Care and Cleaning............10 Installation Options ..............4 ... -
Page 3: Pre-Installation
Pre-installation PLANNING INSTALLATION When installing the ventilation fan in a new construction site, install the main body of the fan and duct work during the rough‑in construction of the building. The grill should be installed after the finished ceiling is in place. When installing in existing construction, use the dimensions on page 12 to determine the required hole size for the ceiling. -
Page 4: Installation Options
Pre-installation (continued) INSTALLATION OPTIONS We recommend installing the ventilation fan by securing the main body of the fan against one ceiling joist and using the header bars as necessary for support of the adjoining joist. There are multiple installation configurations possible for this ventilation fan. Not all configurations are shown. If your installation requires a variation other than those shown, consult with a licensed contractor to determine the best installation for your project. -
Page 5: Hardware Included
Pre-installation (continued) HARDWARE INCLUDED NOTE: Hardware not shown to actual size. Part Description Quantity Long wood screw (M4x30) Short screw (M4x12) Short screw (M4x8) PACKAGE CONTENTS Part Description Fan body Grill Suspension bracket I Suspension bracket II Suspension bracket III... -
Page 6: Installation
Installation Determining joist width Measure the distance from the center of the two ceiling □ joists where you will be installing the ventilation fan. Suspension bracket installation Joint installation under 20 in. □ For ceiling joist installations under 20 in., insert □... - Page 7 Installation (continued) 20 – 24 in. joist installation Duct connection □ Use long wood screws (AA) to loosely attach the □ Install a circular duct (1) to the outlet and secure main body of the fan to one ceiling joist. it with duct tape or clamps to the outlet.
- Page 8 Installation (continued) Connecting wiring from unit to Mounting the grill house □ Use the spring clips to pinch mount and insert the WARNING: Make sure that the main power is off. grill (B) into the narrow rectangular slots inside of the fan housing next to the fan motor.
-
Page 9: Specifications
Specifications CFA-D150(BPT18-44A) Model No. CFA-D150(BPT18-44A) Air direction 150 cfm Voltage 120 V Hertz 60 HZ Duct diameter 6 in. (15.24 cm) Noise 1.5 Sone Power consumption (Watts) 42 W Speed 660 rpm Air deliver at 0.1" WG 150 cfm Weight 10.78 lbs. -
Page 10: Care And Cleaning
Care and Cleaning Before servicing or cleaning the unit, disconnect the power supply at the panel and lock to prevent the power from being turned □ on. If the panel cannot be locked, clearly mark the panel with a warning tag to prevent the power from being turned on. Remove the grill by squeezing the springs and pulling the grill down.
Need help?
Do you have a question about the CFA-D150 and is the answer not in the manual?
Questions and answers