Advertisement
OPERATING INSTRUCTIONS
Specifications
Capacity:
Height Movement:
Ram:
Air Inlet Fitting:
Weight:
Wheel Diameter:
Air Hose:
Air Pressure:
Operation – Lifting
Install the handle assemble well according to assembly drawing.
Turn the hand wheel 26 clockwise until snug.
Adjust the hardle angle degree as needed. Place the jack into position the load.
Adjust the Extension Screw (P10') as needed. Turn counter clockwise to raise and clockwise
to lower.
Connect the air supply hose lock fitting into the air inlet fitting. The lever (A28) should be off
(not in the locked position).
Press the lever (A28) to the on position and lock using lock lever (A27). This provides a con-
tinuous air supply to the Air Motor (48)
Raise the jack by alternately lifting and lowering the handle assembly.
Operation - Lowering
Release the lock lever (A27) to stop air flow to the air motor (48).
Remove air supply hose from the air inlet fitting.
Slowly and carefully lower the load by turning the handwheel counter clockwise in extremely
small increments using only the handle assembly (never use your hand).
Lower the extension screw (P19.1) as needed by turning clockwise.
Remove the jack
CAUTION: Avoid rapid descent of the load. Turn the release valve slowly.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
22 Ton
8-7/8" (Minimum)
17-5/16" (Maximum)
2.1" diameter, 4-3/4" length
1/4: NPT
72
3/8" ((O.D.) x 48" long with crimped hose fittings
120-200 PSI
Seite 11
Advertisement
