Sony UWP-C1, UWP-C2, UWP-C3 Operating Instructions Manual page 32

Parts Identification
2 AF/PEAK (audio frequency/
peak) level indicator
The color indicates the strength of the
audio input signal.
On in red: Audio input level is –40
dBV or more (when the INPUT
selector is set to MIC) or +8 dBV
or more (when the INPUT
selector is set to LINE).
On in green: Audio input level is
–60 dBV or more and less than
–40 dBV (when the INPUT
selector is set to MIC) or –9 dBV
or more and less than +8 dBV
(when the INPUT selector is set
to LINE).
Off: Audio input level is less than
–60 dBV (when the INPUT
selector is set to MIC) or less
than –9 dBV (when the INPUT
selector is set to LINE).
3 INPUT (input signal) selector
Set this selector to MIC when a
microphone is conneted to the audio
input connector; set it to LINE when
an audio mixer, etc. is conneted to the
audio input connector.
Notes
• The UTX-P1 does not support
external power supply. Do not
connect a mirophone which requires
external power supply.
• Do not set the INPUT selector to
MIC position while the audio signal
is being input from the audio mixer,
etc. Doing so may cause excessive
audio input, resulting in distorted
playback or recorded sound or
damage to the playback or recording
equipment.
32
4 Display section
A B
AF RF
CH
The D channel indication for
U66 model is shown.
A AF (audio frequency) indication
Appears whenever the input audio
signal is stronger than the reference
level.
B RF (radio frequency) indication
Appears during signal transmission.
C BATT (battery) indication
Shows the battery condition.
For details, see "Power Supply"on
page 38.
D CH (channel) indication
Shows the transmission channel. Each
time you press the SET button in
transmission mode, the channel
indication changes as follows.
For details, see "Settings" on page
47.
BATT