Advertisement
In the riding mode after 5 seconds, display 2 automatically returns to display 1, and the
original motor power (MOTOR W) display is replaced with motor operating temperature
display (MOTOR ℃) display (the internal motor should be equipped with the temperature
sensor and the output of temperature detection signal).
4.Display 3
Hold
button shortly in display 2 to enter display 3.
In the riding condition, five seconds later, a single maximum speed (MXS)
display automatically returns to the real riding speed (Km/H).
5. In display 3, hold
button shortly (SW),and the display will re-enter display 1.
6.
Hold
button to turn off the display and the power supply of controller.
7.
Automatically prompt interface
Error Code Display
Error Code
Motor position sensor fault!
THROTTLE fault!
The fault is excluded and the fault code display interface is automatically exited.
General Project Setting
1. Set maximum riding speed
Within power on 5 seconds, hold
enter maximum riding speed Km/H and MXS setting, press
riding speed flashing, then press
speed (default 25Km/H). Press
to the next parameter settings.
2. Wheel diameter setting
The wheel diameter will be set after finishing setting the maximum riding
speed, press
wheel diameter specifications flashes. Press
to set the specifications of wheel diameter. Select the range
6,8,10,12,14,16,18,20,22,24,26,700c,28and 29 inches. Press
save and press
to go to the next parameter settings.
Definition
The electronic control system failed to
display the fault code.
There is a fault in the operation, and the
fault code is displayed.
and
at the same time to
maximum
or
to set the maximum riding
button to save the setting, and press
or
button to
3.
Set the metric units
The metric units will be set after finishing setting wheel diameter, press
or
to select the three metric units of speed, mileage, and ambient temperature in
synchronization.
Code
Speed
Km/H
0
MPH
1
Km/H
2
MPH
3
4. Press
UNT stop flash after metric unit setting is completed. Hold
from setting environment of routine projects and save the setting values, returning to display 1.
5. Exit from routine project setting
All three routine project settings can exit from the setting environment and return to the
display by holding
button long after each setting is completed, meanwhile the setting values
are saved.
Under each setting interface, if the button failed holding for more than 1 minute, it will
automatically return to display 1, and the setting value is invalid.
Outline Drawings and Dimensions
1. Dimensions of main instrument body
3.
Dimensions of button box
UNT flash. Press
Mileage
Ambient temperature
Km
℃(Centigrade temperature)
Mil
℃(Centigrade temperature)
Km
℉（Fahrenheit）
Mil
℉（Fahrenheit）
button long to exit
2. Mounting dimensions of double brackets
4. Wiring diagram
Prepared by Suzhou Kunteng Electronics Co., Ltd.
Advertisement
