KUNTENG KT-LCD8S User Manual

KT-LCD8S E-Bike Display User Manual
Dear customer, please read this manual before you use KT-LCD8S Display. The manual will guide you use the instrument
correctly to achieve a variety of vehicle control and vehicle status displays.
Functions and Display
Instruments using the structure form of instrument body portion and the operation buttons are
designed separately.
1
UP Button
2
SW Button
3
DOWN Button
ASSIST
Pas level
4
6Km/H push power assist
5 THROTTLE
Run sign
6 Km/H
Riding speed(metric)
AVS
Average speed
7
MXS
MAX speed
8
Battery capacity indicator
1. Operation
1. ON/OFF
Hold button long to turn on the power, and hold
the power. When the motor stops driving and when the e-bike is not used for a consecutive 5
minutes, it will automatically shut down and turn off the motor power supply.
9 VOL
Battery voltage
10
The brake display
11
Backlight and headlights
℃
Environment temperature
12
℉
Environment fahrenheit
13
MOTOR W
Power display
DST
Trip distance
14
ODO
Total distance
TIM
Single trip time
15
TTM
Total trip time
long for a second time to turn off
2. Display 1
Hold button to start up and enter display .
2.1 Turn on backlight and headlights
Hold long to turn on backlight and headlights (the controller
should have headlight drive output function); hold
turn off the backlight and headlights.
2.2 Assist ratio gear (ASSIST) switch
Press or to switch 1-5 file gear. Gear 1 is for the
minimum power, gear 5 is for the highest power. Each startup will
automatically restore the gear shutdown last time (the user can set
randomly). Gear 0 is without booster function.
2.3 6Km/H assist promotion function
Hold and flashes, the vehicle drives at the speed not more
than 6Km /h. Release button, the function is invalid.
2.4 Display and delete of single data
After power on for 5 seconds, hold
time, single trip riding time (TM) and single trip distance (DST) flash,
hold button shortly, the content of both is cleared. If failed
holding the button within 5 seconds, it will automatically return the
display interface after 5 seconds, original content is preserved.
3.Display 2
Hold button shortly in display 1 to enter display 2.
long again to
and at the same