Page 1
TC4000 AND BEYOND TC4000 S ETUP AND UNCTIONALITY TC4000 Setup and Functionality Document Written 6/17/2019 Version 1.0 PANGOLIN LASER SYSTEMS PANGOLIN.COM – LASERSHOWPROJECTOR.COM...
Setup of TC4000 ....................... 4 Setup Of Timecode In BEYOND ..................5 Setting up a timeline show to use Timecode in Beyond ............6 Checklist for using Timecode in BEYOND with TC4000 ............7 Timecode out with TC4000 ....................8 Page 1 of 8...
Welcome to TC4000 The TC4000 is a SMPTE Timecode converter, It converts analog timecode SMPTE to Midi Timecode (MTC) via USB. This allows for connection as a midi device, allowing for simultaneous input and output of LTC. Because Its over midi, there is no need for an extra driver for this unit, and will work with windows drivers out of the box.
Pangolin Laser Systems TC4000 And Beyond TC4000 Overview On one side we have a USB port, and an RGB status LED, On the other side we have RCA input and output for our Audio LTC, this is slightly different then the TC2000 as the TC2000 had 3 leds on the USB Port side.
Confirmation of incoming timecode will be shown in the preview window and look like the figure above. The RGB LED on the TC4000 will turn RED. If you have never used timecode before, next section is the setup for timecode overall.
Pangolin Laser Systems TC4000 And Beyond Setup Of Timecode In BEYOND Before you can use timecode In beyond at all, you will need to go into your configuration and setup all timecode settings the way you would like to use It.
Pangolin Laser Systems TC4000 And Beyond Setting up a timeline show to use Timecode in Beyond To enable time code within a timeline show, you must right click on the show tab, and click show properties. Then you can select timecode input.
TC4000 And Beyond Checklist for using Timecode in BEYOND with TC4000 1. Ensure your timecode device is connected and configured, in TC4000's case, you connect it over midi device settings. 2. Ensure that you see incoming timecode values (green text) In the preview panel.
To setup Timecode out with TC4000, go to Settings> Configuration> Timecode out Here you can select a midi device number (set to whatever device you set your TC4000 to in Midi settings window) and decide on a timecode format. To output Timecode from a Timeline, you must: Click on a timeline show tab>...