Advertisement
3.5 Menu and LCD display
(Menu navigation for CV-KLQ-LED-6, functions are also applicable to CV-KLQ-LED-9)
CV-KLQ-LED-9
Intens : 50%
CV-KLQ-LED-9
Intens : 33%
*** MENU ***
*** MENU ***
*** MENU ***
DimSteps >
*** MENU ***
Reset all >
*** MENU ***
FW-Info >
*** MENU ***
< Exit Menu
CV-KLQ-LED-9
Intensity has been set to a value (e.g. 50%).
Rotate the incremental encoder (2) to change the intensity
Press the incremental encoder repeatedly to set the intensity values 0, 20,
40, 60, 80, and 100% quickly.
Intensity has been set to 33%. Rotate the incremental encoder (2) to vary
intensity. Press the incremental encoder (2) to access the menu.
*** MENU ***
*** MENU ***
<DimSteps:2%
Reset all?
< NO
Reset all?
< YES
Firmware
Ver.:
Serialnumber
Operating Instructions
By rotating the incremantal encoder (2) you get to the
settings 1 to 6 („SET M1-6") Pre-settings are 0%,
20%, 40%, 60%, 80%, and 100%.
Briefly pressing the incremental encoder (2) again
accesses a sub-menu, where new intensity values
can be set in the 6 memory locations Set M1 to Set
M6 by rotating the incremental encoder (2).
The new value (e.g. 5%) can be saved by briefly
pressing the encoder.
By rotating the incremantal encoder (2) you get to the
menu item "DimSteps". Pre-setting of „DimSteps" is 2.
That means that the intensity can be varied in 2% steps by
rotating the incremental encoder (2). Briefly press the
incremental encoder (2) to access a sub-menu where the
fineness of intensity stages can be adjusted. Here you can
choose from 1% up to 5%.
Confirm the selection by briefly pressing the encoder
again.
Rotate the incremental encoder (2) in the menu to access
the menu item 'Reset all'. Briefly press the incremental
encoder (2) to access a sub-menu where the factory
settings of the device can be re-instated. The display
shows the question 'Reset all?'. Rotate the incremental
encoder to decide between 'NO' and 'YES' and briefly
press the incremental encoder (2) to confirm the selection.
By rotating the incremental encoder (2) you get to the
menu item „FW-Info". Briefly press the incremental
encoder (2) to get information about software version
(„Firmware Ver. xxx) and serial number of the device.
Rotate the incremental encoder (2) in the menu to
access the menu item 'Exit Menu'. Briefly press the
incremental encoder (2) to exit the menu and revert to
normal operation mode.
8
Advertisement
