Page 4
CV-KLQ-LED-9 Operating Instructions Device rear CV-KLQ-LED-9 USB interface Footswitch interface RS232 interface (only with CV-KLQ-LED-9!) CAN interface (only with CV-KLQ-LED-9!) Connection socket for power cable...
Page 6
Please note that you should not dispose of the cold light sources CV-KLQ-LED-9 with domestic waste. If you would like to dispose of your device please send it back to M-Service & Geräte (address p. 15). M- Service & Geräte will dispose of your device professionally and harmlessly to the environment.
CV-KLQ-LED-9 Operating Instructions 3.5 Menu and LCD display (Menu navigation for CV-KLQ-LED-6, functions are also applicable to CV-KLQ-LED-9) Intensity has been set to a value (e.g. 50%). CV-KLQ-LED-9 Rotate the incremental encoder (2) to change the intensity Intens : 50% Press the incremental encoder repeatedly to set the intensity values 0, 20, 40, 60, 80, and 100% quickly.
Page 9
CV-KLQ-LED-9 Operating Instructions Other messages shown in the display With the footswitch (accessory) connected the light source can be CV-KLQ-LED-9 switched on and off quickly. After switch-off of the light source by the * Standby * footswitch, ‘Standby’ will be shown in the display.
Lighting data Maximum usable active diameter of light guide [mm] Total luminous flux at light guide outlet (M-Service & Geräte light guide flexible, active Ø 9 mm, L 1000 mm), stage 100, [lm] Test mark CE, cULus EMC emission class...