Honda CB300R 2019 Manual page 108

Make sure that the lug on the brake
3.
caliper bracket is positioned in the slot on
the swingarm.
Brake caliper bracket
Lug Slot
Swingarm
Tyre Puncture
Adjust the drive chain slack.
4.
Install and tighten the rear axle nut.
5.
Torque: 88 N·m (9.0 kgf·m, 65 lbf·ft)
Tighten the drive chain adjusting nuts
6.
lightly, then hold the adjusting nuts and
tighten the lock nuts.
After installing the wheel, apply the brake
7.
pedal several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Removing Wheels
u
P. 83
2
105