Before Use; Unpacking & Installing - LG MJ3296BFT Owner's Manual

BEFORE USE

Unpacking & Installing
By following the basic steps on these two pages you will be able to quickly check that your oven is operating correctly.
Please pay particular attention to the guidelines on where to install your oven. When unpacking your oven make sure you
remove all accessories and packing materials. Check to make sure that your oven has not been damaged during shipping.
1. Unpack your oven and place it on a flat level surface.
2. Place the oven on the level location of your choice with
more than 85 cm height but make sure there is at least 20
cm of space on the top and 10 cm at the rear for proper
ventilation.
The front of the oven should be at least 8 cm from the edge
of the surface to prevent tipping.
An exhaust outlet is located on bottom or side of the oven.
Blocking the outlet can damage the oven.
3. Plug your oven into a standard household socket. Make sure your oven is the only appliance connected to the socket. If
your oven does not operate properly, unplug it from the electrical socket and then plug it back in.
4. Open your oven door by pulling the door handle. Place the rotating ring inside the oven and place the glass tray on top.
5. Fill a microwave safe container with 300 mL of water.
Place on the glass tray and close the oven door.
If you gave any doubts about what type of container to use please refer to page 13.
6.
Press the STOP/CLEAR button, and press the START/Add 30 secs button
one time to set 30 seconds of cooking time.
Disclaimer: This is only graphical representation of actual product.
Door Latch
Door Seal
BEFORE USE
Oven Front Pate
Safety Door Lock System
7