Sony VAIO VAIO Digital Studio System Reference Manual page 48

36
VAIO Digital Studio System Reference Manual
9
Align the module over the appropriate socket, noting the location of
pin 1 on the module and pin 1 on the socket.
10
Carefully but firmly insert the edge of the module into the socket.
11
Press down firmly and evenly at both corners until the module is
fully seated.
✍
When the module is fully seated, the handles on each side are straight up and
locked into the slot on each side of the module. If the handles are not totally
straight upright, continue to press down on each side of the module until the
handles lock into place.
12
Replace the AGP card and secure using the screw removed earlier.
✍
Be sure to press down firmly until the handle on the AGP slot is straight up and
locked into the slot on the AGP card.
13
Replace the power supply (see
page 45).
14
Replace the side cover (see
15
Reconnect the power cord and turn on the computer.
Your computer automatically recognizes the extra memory and
configures itself accordingly when you turn on the computer. No further
action is required.
Latch
Edge Connector
"Replacing the Power Supply"
"Replacing the Side Cover"
on
on page 25).