Advertisement
DO NOT use for pumping sea water or inflammable, corrosive, explosive or dangerous liquids.
8
DO NOT carry the pump by its electrical cable, or outlet pipe. Use the handle only.
8
When not in use switch off pump and remove plug from power supply. Rinse pump, drain out any water and store in a frost free, safe
8
location.
WARNING! DO NOT allow uncontrolled discharge of contaminated water which would pollute the environment.
‰
2. INTRODUCTION
Manufactured from corrosion resistant materials with - stainless steel motor case and Noryl® base cover
Fitted with automatic cut-out. designed for operation in dense and dirty water. Suitable for the effective drainage of cellars, sinks, cisterns,
baths and the general transfer of water and dense liquids.
3. SPECIfICATION
Model No: ........................................................ WPD235A.V2 ............................................ WPS225A.V2
Cut-out: ................................................................. Automatic .................................................. Automatic
Maximum Head: ..............................................................8mtr ........................................................ 7.5mtr
Maximum Output/Min: ........................................ 217ltr(47gal) .............................................. 225ltr(49gal)
Maximum Particle Size: ................................................ 35mm ........................................................ 15mm
Maximum Water Depth: ...................................................7mtr ........................................................... 5mtr
Minimum Water Depth: ................................................. 40mm ........................................................ 30mm
Motor Power: .................................................................750W ......................................................... 750W
nett Weight: ................................................................5.15Kg ....................................................... 5.98Kg
outlet od: ................................................................. Ø38mm ......................................................Ø38mm
Supply: ...........................................................................230V .......................................................... 230V
WPd235A.V2
fig.1
4. OPERATION
WARNING! Ensure you read, understand and apply safety instructions.
‰
‰
‰
4.1.
Fit appropriate discharge pipe to pump outlet and secure with clip. ensure the diameter of the discharge pipe is the same as, or
greater than, the outlet diameter. A smaller pipe will adversely effect the pump flow rate.
4.2.
Position pump in the water, and place the outlet pipe securely in the discharge receptacle or area. We recommend the pump is
submerged with its discharge outlet facing up to release any trapped air.
4.3.
Plug the pump into the electrical mains supply and switch on. The pump will automatically turn on as the level of water rises (fig.1.A).
As water level lowers, the float will automatically switch the pump off as it reaches the minimum height (B). Float may be adjusted
by shortening or lengthening the cable. The pump will switch on if the water level is up to or above the maximum length of the float
cable. To function correctly the float must move freely. ensure the float can do so and that the cable is not restricted. Check
© Jack Sealey limited
- Stainless steel body and motor case
Original Language Version
- WPD235A.V2
- WPS225A.V2
WPS235A.V2
fig.2
WPD235A.V2 WPS225A.V2 Issue 3 (HF) 10/08/18
Advertisement
