In-Step Mobility U-Step II Step-By-Step Manual page 4

You will need to push in the height adjustment button to slide
the handle bar into the lower height adjustment tube. Left)
Also, when you insert the handlebars make sure that the cables
are routed to the inside of the handlebars, rather than the out-
side. Right)
4) Adjusting the Handlebars to the proper height. Generally, the
handlebars are adjusted so that the handles are 2-3 inches above
your palm when your arm rests at your side.
5) Quick-Release Handle Bar Lock Lever
a. Slide each handle bar in by depressing the
spring-loaded pin at the bottom of the handle bar.
b. Rotate the Quick-Release Locking Lever
clockwise about three to six turns (B1), until the
lever is in the upright position, then flip the
lever straight down to tighten the handle bar
( B2 ).
c. Check whether the handle bar wiggles left or
right. If the handle bar wiggles, unlock the
lever and rotate it another turn clockwise; fold
the lever to tighten, and check again for any
wiggling. Repeat this procedure until the han-
dle bars are sufficiently tight.
— 4 —
Rotate
Clockwise
B1 - Unlocked
Flip
straight
down
B2 - Locked