Advertisement
B
O
ASIC
PERATION
________________________________________________________________________________________________________________________
Power Button: Hold down for approximately 5
seconds to turn on/off. While turned on press
briefly for battery status.
Presets buttons. Comes preprogrammed with:
#1=4 stops, #2=6 stops, #3=8 stops.
Arrows designate direction of rotation.
symbol ">" = right arrow, symbol "<" = left arrow
To execute a preset push buttons:
1< or 1> left or right.
2< or 2> left or right.
3< or 3> left or right.
Power / Status LED Indicator
The combinations of buttons will show the following:
121< Show Mecha ID.
123< Show MAC address.
323< Show Full IP address.
321< Show Last part of the IP address.
v
23< Disable/Enable motor. When the motor is disabled, the power LED will
blink rarely, it blinks also in U.I.
32123< Update the firmware, if possible. Mecha needs to be connected to a
WiFi with internet access before entering the code.It will show "..." if it cannot
find any update, or "!!!" if Internet is not available for Mecha.
MECHA E1 C1 v0.2.1
© Nodal Ninja All rights reserved
5V 2A = Micro B USB Charging Port. Plug in Micro BUSB cable to
charge the Mecha. Use an appropriate power source. 5Volts
2Amp input.
AUX = Multi-function Auxiliary Port. Currently available function
is shutter release confirmation by using signal from camera hot-
shoe. Other functions will be available in the future.
CAM =Camera Port. Plug in a specific shutter cable for the
camera in use. This allows for triggering the shutter
automatically.
Make sure power is turned off
before mounting on a tripod.
Anti-Rotation
Lock
Button.
When mounting to a tripod
depress the button allowing to
tighten the Mecha.
Once
tightened
make
sure
the
button is not depressed.
5
Advertisement
