Triax 383103 Quick Manual page 2

1)
*) Safety
2)
3)
4)
How to install EoC Controller in
an existing coax installation
Mount the Controller in 19" rack or
on the wall with the brackets
*) Safety
Controller units must be correctly earthed
according to applicable national regulations.
Disconnect the output cable from
the TV signal device (shown here with
TV out from a headend)
Connect the cable to one of the EoC out
1-4 on the Controller
Note that each EoC output can support
up to 16 endpoints
Mount a connection cable to connect
your TV signal to the TV in port on the
controller.
Connect your router or internet modem
to the EoC controller with an ethernet
patch cable.
If you use the default setup
- port 2 is for a private network
- port 3 is for guest network
- port 4 is for IP TV
How to install EoC Controller in
an existing coax installation
5)
6)
7)
8)
Connect you laptop to the EoC
controller in ethernet port 1 with
an ethernet patch cable
Open your browser
Type in: http://setup.eoc
Enter username and password at the
logon prompt.
Default login username/password is:
admin/admin
Remember to change this after first
login.
Just follow the 7 steps from the GUI
to set up your EoC Controller
Now you are finished with the
configuration > click Finish and you
will see the System Status