Heated Seats
The seat heaters can be switched
on with the key in steering lock
position 1 or 2.
Heater operation:
Push in upper switch portion;
position 1 = normal heater
operation, one indicator lamp
lights up.
Push in lower switch portion;
position 2 = rapid heating, both
indicator lamps light up.
After approximately 5 minutes in
the rapid heating mode, the
heater automatically switches *o
normal operation and only one
indicator lamp will stay on.
Turning off heater:
If one indicator lamp is on, press
in upper part of switch, position 1.
If both indicator lamps are on,
press in lower part of switch,
position 2.
The heater automatically turns off
after approximately 30 minutes of
operation.
Notes:
When in operation, the seat
heater consumes a large amount
of power. It is advisable not to use
the seat heater longer than ne
cessary.
The seat heaters may automati
cally switch off if too many power
consumers are switched on at the
same time, or if the battery charge
is low. When this occurs, the in
dicator lamp in the switch will
blink (both indicator lamps blink
during rapid seat heating). The
seat heaters will switch on again
as soon as sufficient voltage is
available.
If the blinking of the indicator
lamps is distracting to you, the
seat heaters can be switched off.