Table of Contents
Advertisement
Error messages
If an error message appears while you perform
Auto Calibration, see "When error codes
appear" (page 28) to solve the problem.
If you are unable to remedy the
problem using the
troubleshooting guide
Clearing the receiver's memory may remedy
the problem (page 24). However, note that all
memorized settings will be reset to their initial
settings and you will have to readjust all
settings on the receiver.
If the problem persist
Consult your nearest Sony dealer. Note that if
service personnel changes some parts during
repair, these parts may be retained.
In the event of a problem with S-AIR function,
have a Sony dealer check the entire system
together (S-AIR main unit and S-AIR sub
unit).
Reference sections for clearing
the receiver's memory
To clear
All memorized settings
72
US
Specifications
AUDIO POWER
SPECIFICATIONS
Amplifier section
POWER OUTPUT AND TOTAL HARMONIC
DISTORTION:
(FTC)
(Models of area code U2 only)
FRONT L + FRONT R
POWER OUTPUT (reference)
FRONT L/FRONT R/CENTER/SUR L/SUR R
SUBWOOFER
Inputs
See
page 24
FM tuner section
Tuning range
Antenna
Antenna terminals
Intermediate frequency
AM tuner section
Tuning range
Area code
U2, CA2
Antenna
Intermediate frequency
With 3 ohm loads, both
channels driven, from 180
– 20,000 Hz; rated 84 watts
per channel minimum
RMS power, with no more
than 1% total harmonic
distortion from 250
milliwatts to rated output.
167 W (per channel at
3 ohms, 1 kHz)
165 W (at 3 ohms, 60 Hz)
Analog
Sensitivity: 1 V/50 kohms
Digital (Coaxial) Impedance: 75 ohms
87.5 – 108.0 MHz
(100 kHz step)
FM wire antenna
75 ohms, unbalanced
10.7 MHz
Tuning scale
10 kHz step 9 kHz step
530 –
1,710 kHz
AM loop antenna
450 kHz
531 –
1,710 kHz
Hide quick links:
Advertisement
Table of Contents
