Sony HT-1750DP Operating Instructions Manual page 46

Specifications (continued)
SA-WMSP75 for sub woofer
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 6 ohm loads, from 28 – 200 Hz;
rated 75 watts (SA-WMSP75), minimum RMS
power, with no more than 0.8% total harmonic
distortion from 250 milliwatts to rated output.
Speaker system
Speaker unit
Enclosure type
Continuous RMS power output
(6 ohms, 20 – 250 Hz)
Reproduction frequency range
High frequency cut-off frequency
Input
Power requirements
Power consumption
Dimensions (w/h/d)
Mass
US
46
Active subwoofer,
magnetically shielded
Woofer: 20 cm cone type
Acoustically loaded bass
reflex
75 W
28 Hz – 200 Hz
150 Hz
LINE IN (input pin jacks)
120 V AC, 60 Hz
75 W
Approx.10 3/4 × 12 7/8 ×
15 3/4 inches including
front panel
Approx. 19 lb 14 oz
Supplied accessories
FM wire antenna (1)
AM loop antenna (1)
Speaker connecting cord, long (2)
Speaker connecting cord, short (3)
Monaural connecting cord (1 phono to 1 phono) (1)
Coaxial digital cord (1)
Foot pads (speakers) (20)
Foot pads (subwoofer) (4)
Remote commander (1)
R6 (size -AA) batteries (2)
Speakers
• Front speakers (2)
• Center speaker (1)
• Surround speakers (2)
• Sub woofer (1)
For details on the area code of the component you
are using, see page 4.
Design and specifications are subject to change
without notice.