Kenwood KCH-16 Service Manual page 7

6-2. Connection procedure
1. Connect the Panel assembly (KRK-11) to the transceiver
(TK-5710/5710H/5810/5810H).
2. Connect the Interface box (KRK-11) to the Panel assem-
bly (KRK-11) using the control cable (KCT-22). (Refer to
"1-2. Connecting the KRK-11 Panel assembly and Inter-
face box using the KCT-22 control cable" on page 14 for
installation details.)
3. Connect the KCH-16 cable to the Interface box.
4. Connect the Interface box to the computer using the
interface cable (KPG-43/43A) and USB adapter (KCT-53U
: the KCT-53U can be used with the KPG-43A interface
cable.)
Notes:
• You must install the KCT-53U driver in the computer to
use the USB adapter (KCT-53U).
• When using the USB adapter (KCT-53U) for the first
time, plug the KCT-53U into a USB port on the com-
puter with the computer power ON.
5. When the POWER is on, you can immediately enter user
mode. When the PC sends a command to the transceiv-
er, it enters PC mode and "PROGRAM" is displayed on
the LCD.
When data is transmitting from the transceiver, the red
LED lights.
When data is receiving by the transceiver, the green LED
lights.
Note:
The data stored in the computer must match the "Model
Name and Market Code" when it is written into the EE-
PROM and fl ash memory.
6-3. KPG-43/KPG-43A description
(PC programming interface cable: Option)
The KPG-43/43A is required to connect the KRK-11 (In-
terface box) to the computer. It has a circuit in its D-sub con-
nector (KPG-43: 25-pin, KPG-43A : 9-pin) case that converts
the RS-232C logic level to the TTL level.
The KPG-43/43A connects the programming connector
of the KRK-11 (Interface box) to the RS-232C serial port of
the computer.
6-4. KCT-53U description (USB adapter: Option)
The KCT-53U is a cable which connects the KPG-43A to
a USB port on a computer.
When using the KCT-53U, install the supplied CD-ROM
(with driver software) in the computer. The KCT-53U driver
runs under Windows 2000 or XP.
6-5. Programming software KPG-95D description
The KPG-95D is the programming software for the trans-
ceiver supplied on a CD-ROM. This software runs under
MS-Windows 98, ME, Windows 2000, XP or Vista (32-bit)
on an IBM-PC or compatible machine.
The data can be input to or read from the transceiver and
edited on the screen. The programmed or edited data can
be printed out. It is also possible to tune the transceiver.
REALIGNMENT
7. PC Tuning Mode
When making adjustment while in PC tuning mode,
modify the KPG-43/43A programming interface cable as de-
scribed below.
1. Remove the two screws from the plug cover, then lift
the cover from the plug.
2. Solder the lead wire onto the MIC tab on the PCB, and
the ground wire onto the ME tab.
• KPG-43
• KPG-43A
3.
• KPG-43
Create a hole in the casing (as shown in the illustration)
then fi t the cable into the hole. Replace the cover and
secure it using the two screws.
KCH-16
+ +
+
C2
Q1
D1
Q2
Q3
MIC
ME
Cable
MIC Create a hole
ME
7