Kenwood KCH-16 Service Manual page 29

Note:
Because the key name of the KCH-16 is different from
the KCH-14/15, when using the KCH-16, the panel test
mode, panel tuning mode, adjustment method, etc., of the
TK-5710/5710H/5810/5810H is described.
Furthermore, in the adjustment methods (pages 39 to
54), key names that relate to that of the KCH-16 are listed in
shaded boxes.
Panel Test Mode
■ Test mode operation features
This transceiver has a test mode. To enter test mode,
press and hold the [S] key while turning the transceiver
power ON. Test mode can be inhibited by programming.
To exit test mode, turn the transceiver power OFF.
• When the panel test mode is activated, the last used
channel and signaling numbers are displayed. When the
panel test mode is activated for the fi rst time, the chan-
nel and signaling numbers are 1.
• If test signaling 20 (Tone Test Pattern) is selected, the re-
sult of Bit Error Rate (BER) calculation is displayed on the
LCD. The BER value is also output from the serial port.
■ Key operation
"FNC" not appears
Key
Function
[ ], [ ] Wide/Narrow/P25
Shifts to the Panel tuning
[ ]
mode
[ ] Squelch off
Push: Test frequency chan-
nel down
[S] Hold: Test frequency
channel continuation
down
ADJUSTMENT
Display
Wide: "W" appears
Narrow: "N" appears
P25: "A" appears
-
icon appears
Channel No.
"FNC" not appears
Key
Function
Push: Test frequency chan-
nel up
[A]
Hold: Test frequency chan-
nel continuation up
Push: Test signaling down
[B] Hold: Test signaling con-
tinuation down
Push: Test signaling up
[C] Hold: Test signaling con-
tinuation up
[Orange] Function on
[PTT] Transmit
Use as the DTMF keypad.
[0] to [9] If a key is pressed during
and transmission, the DTMF
[ ], [ ] corresponding to the key
that was presses is sent.
"FNC" appears
Key
Function
[ ], [ ] Function off
[ ] Squelch level 0
[ ] High power/Low power
[S] Compander on/off
[A] LCD all lights
[B] MSK 1200bps/2400bps
[C] Beat shift on/off
[Orange] Function off
[PTT] Transmit
[0] to [9]
and Function off
[ ], [ ]
• LED indicator
Red LED Lights during transmission.
Green LED Lights when there is carrier.
• LCD display in the panel test mode
W : Wide
N : Narrow
A : P25
W
1 - 1
Channel No.
KCH-16
Display
Channel No.
Signaling No.
Signaling No.
"FNC" appears
-
-
Display
-
On: icon appears
Low: icon appears
On: icon appears
LCD all point appears
2400bps: icon
appears
On: icon appears
-
-
-
Signaling No.
29