Operating The Mixer - Hamilton Beach HMD300 Operation Manual

Operating the Mixer

Mixing a Drink
w WARNING Cut Hazard.
Do not put spoon or other utensils in container
when mixing. Failure to follow these instructions
can result in cuts.
Mixing a Drink
You must read the "Mixer Safety" section before
using the mixer.
For best mixing results, use the Hamilton Beach
Universal Container (#110E). Do not use a paper
cup. The container fits the container guide which
starts the motor.
1. Plug mixer into a grounded outlet.
2. Place the ingredients into the container.
The basic milkshake recipe is:
• 3 No. 24 scoops of ice cream
• 4 ounces of very cold milk
• 1 1 ⁄ ounces of syrup
2
Using the Container Rest
Two-Position Container Rest
The top container rest position is used when
mixing with a standard container. In the top
position, a standard container will fit into the
container guide to lift the ON/OFF actuator
against the actuator switch, allowing the motor
to run. To turn off the motor, rest a standard
container on the lower, or standby, container
rest position.
3. Select the desired speed using the two-speed
selector switch.
4. Position the container into
the container guide and
move the cup upward to
automatically turn the
motor on. Set the container
down onto the cup rest.
NOTE: You may also turn
the motor ON (I) and OFF
(O) using the pulse switch.
5. When the drink is completely mixed, lift the
container up off the cup rest and pull down
from the container guide. The motor will turn off.
NOTE: Inspect agitator(s) daily. Replace
agitator(s) every 90 days.
The lower container rest position may also be used
when mixing with larger containers, or for storing
standard containers when the mixer is not in use.
NOTE: When container is not positioned as
described above, you may also turn the motor on
using the pulse switch.
5