Ky-Cl2F-D Device Unit Configuration; Ky-Cl2F-H Host Unit Configuration; Table 5 : Terminal Commands For - Kaya Instruments KY-CL2F-D User Manual

6.2.2 KY-CL2F-D Device Unit configuration

Command
firmware
status
default
Save
NOTE: The commands are not case sensitive.

6.2.3 KY-CL2F-H Host Unit configuration

In order to format the system, choose the required command sequence:
Command
format
uartbaud
Configuration example:
Setting serial port CameraLink Uart baud rate 9600, Deca8 mode area scan.
To configure the host to the described mode, follow the commands:
a. uartbaud 0 0
b. format 5
Camera Link Range Extender over Fiber User Manual
Sets the system to firmware update mode. See 6.3 chapter for firmware update
information
Prints the system and link status and general information
Reset user settings
Save user settings to flash
Table 5 : Terminal commands for Device unit
Description
mode
type
port
baud
Table 6 : Host unit configuration
Description
Available options
1- Base mode
2- Medium mode
3- Full mode
4- Deca10(8Taps) mode
5- Deca8(10Taps) mode
1- AreaScan
2- LineScan
0-CameraLink
1-RS232_0
2-RS232_1
3-RS422
0-9600
1-19200
2-38400
3-57600
4-115200
5-230400
6-460800
7-921600
Firmware
20