End Gate Installation - abi Classic Spreader 25 Owner's Manual

End Gate Installation

Using a screwdriver and hammer remove the two
square punch outs on each side of the spreader.
These punch outs are located along the top edge of
the box of the spreader.
Remove the two bolts, nuts, and lockwashers from
the brackets on the end gate.
Line up the brackets with the punched out holes.
Insert the bolts from the bottom side and then
install the lockwasher and nut. Once you have all 4
bolts in place, tighten down the nuts and your end
gate is installed.
© Copyright 2017 ABI Attachments, Inc.
22