Table of Contents
Advertisement
Examples of poor conditions of the speaker cord
Stripped speaker cord is
touching another speaker
terminal.
After connecting all the components, speakers, and AC power cord (mains lead), output a test tone to
check that all the speakers are connected correctly. For details on outputting a test tone, see page 83.
If no sound is heard from a speaker while outputting a test tone, or a test tone is output from a speaker
other than the one currently displayed on the Setup Display, the speaker may be short-circuited. If this
happens, check the speaker connection again.
Note
• Be sure to match the speaker cord to the appropriate terminal on the components: 3 to 3, and # to #. If the cords
are reversed, the sound will lack bass and may be distorted.
Installing the speakers on the wall
1
Prepare screws (not supplied) that are suitable for the hole on the back of each speaker.
See the illustrations below.
25 mm (1 inch)
2
Fasten the screws to the wall.
The screws should protrude 7 to 8 mm (9/32 to 11/32 inch).
7 to 8 mm
9
11
(
/
to
32
3
Peel the seals off the two screw points on the rear of the speaker.
5
4 mm (
/
inch)
32
/
inch)
32
Stripped cords are touching each
other due to excessive removal of
insulation.
Hole on the back of
4.6 mm
the speaker
3
(
/
inch)
16
10 mm
13
(
/
inch)
32
1
165 mm (6
/
inch)
2
continued
21
GB
Hide quick links:
Advertisement
Table of Contents
