Sony CMT-SX2D Operating Instructions Manual page 11

Connection B (For European and
Russian models)
Connect the t INPUT jack of your TV
to the T LINE-TV jack with the SCART
cord (not supplied). Make sure to set
the VIDEO OUT SELECTOR to EURO
AV.
When you connect using the SCART cord,
check that the TV conforms to RGB signals.
If the TV conforms to RGB signals, change
the input mode of the TV to RGB signals.
Refer to the operating instructions supplied
with the TV to be connected.
Note
Only the video signal will be output through the
SCART cord.
Connection C (Except for European
and Russian models)
Connect the video input jack of your TV
to the VIDEO OUT jack with the video
cable (supplied)*.
* except for European and Russian models
When using a TV
Turn on the TV and select the video input so that you
can view the pictures from this system.
When connecting a video deck
Connect the TV and the video deck using video and
audio cords (not supplied) as shown below.
TV
Video deck
Do not connect
directly.
If you connect a video deck between this system and the
TV, you may experience video leakage when watching
the video signal from this system. Do not connect a
video deck between this system and the TV.
Note
Do not place the TV on this system.
4 For models with a voltage selector, set
the VOLTAGE SELECTOR to the local
power line voltage.
Depending on the model, the VOLTAGE
SELECTOR may differ.
5 Connect the power cord to a wall
outlet.
If the supplied adapter on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adapter).
To turn on the system, press ?/1.
Note
Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
System
continued
GB
11