Storage Instructions; Inflation Option - Intex Fast-Fill AP619C Owner's Manual

3. When the airbed is completely deflated, begin rolling the airbed from the foot of
the airbed towards the head of the airbed where the pump is located. See Fig (7).
4. When all air is removed from the airbed, slide the switch up to the Off mark
( ). See Fig (3).
5. Disconnect the AC line cord from the wall socket, place it inside the cord compartment.
Never disconnect the power line cord from the pump or from the electrical outlet while the pump
is operating. Switch OFF (

INFLATION OPTION

1. If electrical power is not available then a conventional foot
or manually operated air pump can be connected to the
air passage (6) for inflation. See Fig (8).
2. Slide the switch up to the inflation mark (
3. Insert air pump nozzle to the air passage to inflate the
airbed.
4. When the airbed is fully inflated to the desired firmness,
slide the switch down to the Off mark (
line on the switch must be aligned with the dot to
ensure the internal air passage is closed.
Note: Inflate only with a low pressure inflator. Do not over
inflate. Fill with cold air only.

STORAGE INSTRUCTIONS

1. Deflate the airbed following the "DEFLATION" instructions.
2. Make sure the airbed is clean and dry.
3. Lay bed flat with sleeping surface facing upwards and follow the folding steps on Figs
(9 - 13). Fold the airbed loosely and avoid sharp bends, corners and creases which can
damage the airbed.
FIG (9)
FIG (12)
4. Place the airbed inside the storage bag and store in a dry, cool storage location.
©2018 Intex Marketing Ltd. - Intex Development Co. Ltd. - Intex Recreation Corp. All rights reserved/Tous droits réservés/Todos los derechos
reservados/Alle Rechte vorbehalten. Printed in China/Imprimé en Chine/Impreso en China/Gedruckt in China.
®™ Trademarks used in some countries of the world under license from/®™ Marques utilisées dans certains pays sous licence de/Marcas registradas
utilizadas en algunos países del mundo bajo licencia de/Warenzeichen verwendet in einigen Ländern der Welt in Lizenz von/Intex Marketing Ltd. to/à/a/
an Intex Development Co. Ltd., G.P.O Box 28829, Hong Kong & Intex Recreation Corp., P.O. Box 1440, Long Beach, CA 90801 • Distributed in the
European Union by/Distribué dans l'Union Européenne par/Distribuido en la unión Europea por/Vertrieb in der Europäischen Union durch/Intex Trading
B.V., Venneveld 9, 4705 RR Roosendaal – The Netherlands
www.intexcorp.com
READ AND SAVE THESE INSTRUCTIONS
(150PO) AP619C BUILT-IN ELECTRIC PUMP ENGLISH 4.875" X 7.25" 06/15/2018
IMPORTANT
) the pump first before disconnecting the power line cord.
). The
FIG (10)
FIG (13)
Page 4
).
150
English
PO
FIG (8)
FIG (11)
Consumer Service 1-800-234-6839