Manual Inflation Option; Deflation; Storage Instructions - Intex FastFill AP619DA Owner's Manual

DEFLATION

1. Plug in the AC power cord into an AC electrical outlet. See Fig (2).
2. Press the deflation button (
3. When all the air is removed from the
Note: The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended.
4. With the air bed fully deflated begin rolling the
towards the end where the pump is located. See Fig (7).
5. Disconnect the AC power cord from the electrical outlet, coil the line cord and place it
inside the cord compartment, then close the cover. Make sure the power cord is free of
twists, kinks or knots.

MANUAL INFLATION OPTION

If electrical power is not available, a conventional foot, manual, or battery-operated air
pump can be used by connecting it to the manual inflation port located inside the line cord
compartment. See Fig (8). Follow these steps:
1. Open line cord compartment cover.
2. Remove the cap from the manual inflation port
and insert the nozzle of the pump into the port.
Inflate the airbed to desired firmness.
NOTE: Do not overinflate. The firmness should be
approximately the same as the level achieved with
the internal electric pump.
3. Remove nozzle from manual inflation port and
close the cap and the line cord cover.

STORAGE INSTRUCTIONS

1. Deflate the air bed
2. Make sure the air bed
3. Lay the air bed flat with the sleeping surface facing upwards and follow the folding steps
on Figs (9 - 13). Fold the
which can damage the
FIG (9)
4. Place the air bed
READ AND SAVE THESE INSTRUCTIONS
) to deflate.
FIG (6)
air
following the "DEFLATION" instructions.
is clean and dry.
air bed loosely and avoid sharp bends, corners and creases
air bed.
FIG (10)
inside the storage bag and store in a dry place.
(20PO) AP619DA ELECTRIC PUMP ENGLISH 4.875" X 7.25" 08/25/2022
See Fig (6).
bed, press " " again to switch OFF.
air bed from the end opposite of the pump
FIG (11) FIG (12)
Page 4
FIG (7)
FIG (8)
FIG (13)
20
PO